EL3060 CONTINUOUS GAS ANALYZERS | OI/EL3060-EN REV. A 9
Safety instructions
Requirements for safe operation
In order to operate in a safe and efficient manner the device should be
properly handled and stored, correctly installed and set up, properly oper-
ated and correctly maintained.
Qualifications of the personnel
Only persons familiar with the installation, commissioning, operation and
maintenance of comparable devices and certified as being capable of such
work should work on the device.
Instructions and regulations to be observed
These include
• The contents of this operating instruction,
• The safety information affixed to the device,
• The applicable safety regulations for installing and operating electrical
devices,
• The applicable safety regulations for working with gases, acids, con-
densates, etc.
National regulations
The regulations and norms, standards and directives cited in this operating
instruction are applicable in the Federal Republic of Germany. The applicable
national regulations should be followed when the device is used in other
countries.
Device safety and safe operation
The device has been designed and tested in accordance with EN 61010
Part 1, "Safety requirements for electrical equipment for measurement, con-
trol, and laboratory use" and has been shipped ready for safe operation.
In order to maintain this condition and to assure safe operation, safety in-
formation in this operating instruction must be observed. Failure to do so
can put persons at risk and can lead to device damage as well as damage to
other systems and devices.
Comply with the safety regulations
The safety regulations for explosion protection must be complied with
without fail before carrying out any work on the device.
Carrying out work with an explosion hazard is prohibited
Carrying out work on live parts, with the exception of intrinsically safe cir-
cuits, and with auxiliary equipment which represents a danger of ignition is
prohibited if there is an explosion hazard.
Equipotential bonding connection
The local potential equalization must be connected before any other con-
nections are made.
To Next Page
Loading...
Need help?
General
