Appendix A – PROFIdrive parameters and I&M records of PROFINET IO
32 – Traversing block
selection (SATZANW)
(not supported)
Unsigned16
33 – Actual traversing
block (AKTSATZ) (not
supported)
Unsigned16
34 – Target position
(TARPOS_A) (not
supported)
Signed32
35 – Velocity
(VELOCITY_A)
Unsigned32
101…9999 – Drive-
specific
–
927 R/W Unsigned16 Operator control rights (parameter
identification, PKW)
Value Mode
0 Parameters cannot be
written, only read (927
can be written).
1 Parameters can be
written and read (default).
928 R/W Unsigned16 Control rights (process data, PZD).
Value Mode
0 PZD part is disabled, ie,
Receipt of new PZD data
is ignored.
1 PZD part is enabled
(default).
Par. no. R/W
1)
Data type Description
To Next Page
Loading...
