258 PROFINET IO – Start-up
FENA-01/-11/-21 configuration parameters – group B (group 2)
Note: The actual parameter group number depends on the drive
type. Group B (group 2) corresponds to:
• parameter group 55 in ACS355
• parameter group 53 in ACSM1, ACS850 and ACQ810
• parameter group 53 in ACS880 and ACS580 if the adapter is
installed as fieldbus adapter A or group 56 if the adapter is
installed as fieldbus adapter B.
No.
1)
Name/Value Description Default
01 DATA OUT 1
(master to drive)
Selects data word 1 received by the drive over
the PROFINET network. The content is defined
by a decimal number in the range of 0 to 9999
as follows:
See also Virtual address area allocation with
ACSM1 on page 261.
1 or 11
2)
ACS355:
FBA DATA OUT 1
ACSM1:
FBA DATA OUT1
ACS850/ACQ810:
FBA data out1
ACS880/ACS580:
FBA A/B data out1
0 = None Not used
1 = CW 16bit Control word (16 bits)
3)
2 = Ref1 16bit Reference REF1 (16 bits)
3)
3 = Ref2 16bit Reference REF2 (16 bits)
3)
11 = CW 32bit Control word (32 bits)
12 = Ref1 32bit Reference REF1(32 bits)
13 = Ref2 32bit Reference REF2 (32 bits)
21 = CW2 16bit Control word 2 (16 bits)
101…9999 Parameter index with format xxyy, where
• xx is the parameter group number (1…99)
• yy is the parameter number index within
that group (01…99).
Note: In ACS880 and ACS580, choose Other
to display a list of mappable drive parameters.
0 Not used
1…99 Virtual address area of drive control
101…
9999
Parameter area of the drive
To Next Page
Loading...
