ABB i-bus KNX Yucus YUB/U1.0.1 Series User Manual

KNX Technical Reference Manual
ABB i-Bus
®
KNX Yucus
99
12.32.8 Extended parameter – Send behavior
Options For every object receipt
Only with a change of the output object
The parameter “Send behavior” sets weather an outgoing signal should only be sent if
the ingoing value changed or not.
12.32.9 Extended parameter – Upper threshold (%)
Options
0 to 100
The "Upper threshold (%)" parameter specifies the upper threshold. i.e. if the value on
the "Input" object is higher than the set value, the "Output value for exceeding the upper
threshold" telegram is sent out on the "Output" communication object. Values from 0 to
100 % can be set in 2.55 % steps.
12.32.10 Extended parameter – Output value for exceeding the upper threshold
Options Off
On
The parameter "Output value for exceeding the upper threshold" specifies the value that
is sent out on the 1-bit communication object "Output" if the set upper threshold is
exceeded. The values ON and OFF can be set.
12.32.11 Extended parameter – Lower threshold (%)
Options 0 to 100
The "Lower threshold (%)" parameter specifies the lower threshold. i.e. if the value on
the "Input" object is lower than the set value, the "Output value for falling below the lower
threshold" telegram is sent out on the "Output" communication object. Percent values
from 0 to 100 % can be set in 2.55 % steps.
12.32.12 Extended parameter – Output value for failing below the lower threshold
Options Off
On
The parameter "Output value for falling below the lower threshold" specifies the value
that is sent out on the 1-bit communication object "Output" if the set upper threshold is
fallen below. The values ON and OFF can be set.

ABB i-bus KNX Yucus YUB/U1.0.1 Series Specifications

General

Brand	ABB
Model	i-bus KNX Yucus YUB/U1.0.1 Series
Category	Temperature Controller
Language	English