ABB i-bus KNX Yucus YUB/U1.0.1 Series - Application 1-Button Operating Mode, Adjust Thermostat Settings

KNX Technical Reference Manual
ABB i-Bus
®
KNX Yucus
59
12.15.9 Object no
Object name
Data type
Flags
Value switching for short
operation
1 bit DPT 1.001 C, W ,T ,U
Value switching for short
operation
1 byte DPT 5.001 C, W ,T ,U
Value switching for short
operation
1 byte DPT 5.010 C, W ,T ,U
Value switching for short
operation
2 byte DPT 9.xxx C, W ,T ,U
Value switching for short
operation
2 byte DPT 8.001 C, W ,T ,U
Value switching for short
operation
2 byte DPT 7.001 C, W ,T ,U
Value switching for short
operation
4 byte DPT 14.xxx C, W ,T ,U
Value switching for short
operation
4 byte DPT 13.001 C, W ,T ,U
Value switching for short
operation
4 byte DPT 12.001 C, W ,T ,U
Value switching for long
operation
1 bit DPT 1.001 C, W ,T ,U
Value switching for long
operation
1 byte DPT 5.001 C, W ,T ,U
Value switching for long
operation
1 byte DPT 5.010 C, W ,T ,U
Value switching for long
operation
2 byte DPT 9.xxx C, W ,T ,U
Value switching for long
operation
2 byte DPT 8.001 C, W ,T ,U
Value switching for long
operation
2 byte DPT 7.001 C, W ,T ,U
Value switching for long
operation
4 byte DPT 14.xxx C, W ,T ,U
Value switching for long
operation
4 byte DPT 13.001 C, W ,T ,U
Value switching for long
operation
4 byte DPT 12.001 C, W ,T ,U
12.16 Application “1-button operating mode, “Adjust thermostat settings”
With the "1-button operating mode" "Adjust room temperature controller"" application, an
operating mode switchover for connected room temperature controllers can be carried
out with an operation of one button side.
Depending on the setting of the "Object type for output" parameter, the application offers
either 1-bit communication objects "Comfort operating mode", "Standby operating mode",
"ECO operating mode" and Frost protection, heat protection operating mode" or 1-byte
communication objects "Auto operating mode", "Comfort operating mode", "Standby