ABB i-bus KNX Yucus YUB/U1.0.1 Series - Page 59

KNX Technical Reference Manual
ABB i-Bus
®
KNX Yucus
58
Value 1 is specified here which is sent out at a short operation of the button. This is
dependent on the setting of the "Object type" parameter.
12.15.6 Extended parameter – Value 2 for short operation
Options Off
On
Note”: This parameter is only visible if the "Reaction at short operation"
parameter is set on either "Value 2" or "Alternating Value1/Value2".
Value 2 is specified here which is sent out at a short operation of the button. This is
dependent on the setting of the "Object type" parameter.
12.15.7 Extended parameter – Value 1 for long operation
Options Off
On
Note”: This parameter is only visible if the "Reaction at long operation" parameter
is set on either "Value 1" or "Alternating Value1/Value2".
Value 1 is specified here which is sent out at a long operation of the button. This is
dependent on the setting of the "Object type" parameter.
12.15.8 Extended parameter – Value 2 for long operation
Options Off
On
Note”: This parameter is only visible if the "Reaction at long operation" parameter
is set on either "Value 2" or "Alternating Value1/Value2".
Value 2 is specified here which is sent out at a long operation of the button. This is
dependent on the setting of the "Object type" parameter.