KNX Technical Reference Manual
ABB i-Bus
®
KNX Yucus
57
12.15.2 Common parameter – Reaction for short operation
Options No reaction
Value 1
Value 2
Alternating value1/value2
Here it is specified whether the "Value 1" or the "Value 2" is sent out for a short operation
of the button. Alternatively, Value1/Value2 can also be alternatingly set for a short
operation, i.e. after Value 1 was sent (or received), a renewed operation will send out a
Value 2. After it is operated again, Value 1 is again sent out. The "No reaction" setting
causes no telegram to be sent out for a short operation of the button.
12.15.3 Common parameter – Reaction for long operation
Options No reaction
Value 1
Value 2
Here it is specified whether the "Value 1" or "Value 2" is sent out for a long operation of
the button. Alternatively, Value1/Value2 can also be alternating set for a long operation,
i.e. after Value 1 was sent (or received), a renewed operation will send out a Value 2.
After it is operated again, Value 1 is again sent out. The "No reaction" setting causes no
telegram to be sent out for a long operation of the button.
12.15.4 Extended parameter – Duration of long operation (ss:ms)
Options Time input from 0.3 to 3.0 seconds
A differentiation can be made between a short or long operation of the button. With a
short operation of the button, the next level forward is switch to in each case. With a long
operation, the first level is activated. Thus, with a long button press a jump back from
every position to the first level is possible, without having to run through the remaining
levels.
Via the "Duration of long operation", the time is specified from which a long button press
is recognized, and the object values are reset. The first level must be set again with a
press of the button. Any time from 0.3 to 3 seconds can be set. A typical value after which
a jump-back to level 1 is set at 0.4 s.
12.15.5 Extended parameter – Value 1 for short operation
Options Off
On
Note”: This parameter is only visible if the "Reaction at short operation"
parameter is set on either "Value 1" or "Alternating Value1/Value2".
To Next Page
Loading...
Need help?
General
