ABB i-bus KNX Yucus YUB/U1.0.1 Series User Manual

KNX Technical Reference Manual
ABB i-Bus
®
KNX Yucus
20
8 Commissioning
8.1 Software
To start using the control element a physical address must be assign first. The physical
address is assigned, and the parameters are set with the Engineering Tool Software ETS
(min from version ETS 5).
8.2 Preparatory steps
1. Connect a PC via the KNX interface, e.g. the commissioning interface / adapter
IP/S 3.1.1, to the KNX bus line. The Engineering Tool Software ETS must have
been install on the PC.
2. Switch on the bus voltage.
8.3 Assigning a physical address
Use a tool to press the programming button at the bottom of the control element (right
side, specified hole). The diameter of the tool should be less than 2mm.
Note
The control elements are products of the KNX system and meet KNX
guidelines. Detailed expert knowledge by means of KNX training
sessions for a better understanding is assume.

ABB i-bus KNX Yucus YUB/U1.0.1 Series Specifications

General

Brand	ABB
Model	i-bus KNX Yucus YUB/U1.0.1 Series
Category	Temperature Controller
Language	English