KNX Technical Reference Manual
ABB i-Bus
®
KNX Yucus
133
This preset is used to limit the manual increase during heating mode.
12.34.89 Changing set value – Maximum manual reduction during heating mode (°C)
Options Input from 0 to 9
Note: Only available when the "Device function" parameter is set on either
"Single device" or "Master device", and the Control function parameter is set on “Heating”,
“Heating with additional stage”, "Heating and cooling" or "Heating and cooling with
additional stages".
This preset is used to limit the manual reduction during heating mode.
12.34.90 Changing set value – Maximum manual increase during cooling mode (°C)
Options Input from 0 to 9
Note: Only available when the "Device function" parameter is set on either
"Single device" or "Master device", and the Control function parameter is set on “Cooling”,
“Cooling with additional stage”, "Heating and cooling" or "Heating and cooling with
additional stages".
This preset is used to limit the manual increase during cooling mode.
12.34.91 Changing set value – Maximum manual reduction during cooling mode (°C)
Options Input from 0 to 9
Note: Only available when the "Device function" parameter is set on either
"Single device" or "Master device", and the Control function parameter is set on “Cooling”,
“Cooling with additional stage”, "Heating and cooling" or "Heating and cooling with
additional stages".
This preset is used to limit the manual reduction during cooling mode.
12.34.92 Changing set value – Resetting of the manual adjustment for receipt of a
basic setpoint
Options No
Yes
To Next Page
Loading...