ABB i-bus KNX Yucus YUB/U1.0.1 Series - Page 86

KNX Technical Reference Manual
ABB i-Bus
®
KNX Yucus
85
12.27.6 Extended parameter – Save input signal
Options Deactivate
Activate
Via the "Save input signal", you can set whether the signals are saved or not for 1-bit
input and output objects "During the blocking phase".
Example: Data flow direction: Input towards the output. If the setting "Activate" is select,
the output sends out its value if a telegram has been receive on the input during the
blocking phase.
12.27.7 Object no
Object name
Data type
Flags
Input 1 bit DPT 1.001 C, W
Input
2 bit DPT 2.001
C, W
Input 4 bit DPT 3.007 C, W
Input
1 byte DPT 5.001
C, W
Input 1 byte DPT 5.010 C, W
Input
2 byte DPT 9.xxx
C, W
Input
2 byte
DPT 8.001
C, W
Input 2 byte DPT 7.001 C, W
Input
3 byte DPT 10.001
C, W
Input 3 byte DPT 11.001 C, W
Input
4 byte DPT 14.xxx
C, W
Input 4 byte DPT 13.001 C, W
Input 4 byte DPT 12.001 C, W
Input
1 bit DPT 1.001
C, T
Input 2 bit DPT 2.001 C, T
Input
4 bit DPT 3.007
C, T
Input 1 byte DPT 5.001 C, T
Input
1 byte DPT 5.010
C, T
Input
2 byte DPT 9.xxx
C, T
Input 2 byte DPT 8.001 C, T
Input
2 byte DPT 7.001
C, T
Input 3 byte DPT 10.001 C, T
Input
3 byte
DPT 11.001
C, T
Input 4 byte DPT 14.xxx C, T
Input
4 byte DPT 13.001
C, T
Input
4 byte DPT 12.001
C, T
Output 1 bit DPT 1.001 C, W
Output
2 bit DPT 2.001
C, W
Output 4 bit DPT 3.007 C, W
Output
1 byte DPT 5.001
C, W
Output 1 byte DPT 5.010 C, W
Output 2 byte DPT 9.xxx C, W
Output
2 byte DPT 8.001
C, W
Output 2 byte DPT 7.001 C, W
Output
3 byte DPT 10.001
C, W
Output 3 byte DPT 11.001 C, W