ABB LMT Series - Control Application Process (CAP)

66
LMT100 AND LMT200 | MAGNETOSTRICTIVE LEVEL TRANSMITTERS | FF OI/LMT100/200/FF-EN REV. A
Control Application Process (CAP)
The CAP is used by the control engineer for configuring the
plant control strategy and for this reason mainly focused on the
Function Blocks of the device.
Important. For convenience, all the device parameters
mentioned in this document are written with the prefix
indicating the block into where they are mapped:
– RB_ = Resource Block
– LTB_ = Level Transducer Block
– HMI_ = HMI Transducer Block
– AIx _ = Analog Input Function Blocks where the x is the
number of the AI (1, 2, 3)
Figure 37 Device function block application