ABB LST300 - Switching to the configuration level parameterization; Selecting and changing parameters

24 LST300 | COMPACT ULTRASONIC LEVEL TRANSMITTER | LST300–EN REV. E
2 Press or to select the “Diagnostics” submenu.
3 Press to confirm your selection
The first line indicates where the error has occurred.
The second line shows the unique error number.
The next lines show a brief description of the error and its
remedy information.
IMPORTANT (NOTE)
Refer to chapter 7 “Diagnostic Messages” for a detailed
description of the errors and remedy information.
Switching to the configuration level parameterization
The device parameters can be displayed and changed on the
configuration level.
1 Press
to switch to the information level.
2 Press or to select an access level.
3 Press to confirm your selection
IMPORTANT (NOTE)
There are four access levels as follows:
• At the “Read Only” level all entries are disabled. Parameters
are read only and cannot be modified.
• At the “Standard” level you can edit all parameters except for
those written in italics.
• At the “Advanced” level all parameters can be modified.
• The Service menu is reserved to the customer service.
Passwords can be defined for the “Standard” and “Advanced”
levels. There are no factory default passwords.
Password can be edited or reset once you have logged on to the
corresponding access level. To reset to the “No password
defined” state, select “-” as the password.
4 Enter the corresponding password (see section “Selecting
and changing parameters”).
Note
There is no factory default password. You can switch to the
configurationlevel without entering a password.
Note
The selected access level remains active for 3 minutes. Within
this time period, you can toggle between the process display
and the configuration levelwithout re-entering the password.
5 Press to switch to the information level. The LCD display
now indicates the firstmenu item at the configuration level
6 Press
or to select a menu.
7 Press
to confirm your selection
Selecting and changing parameters
Selecting a parameter value
1 Select the parameter you want to set in the menu.
2 Press to see the list of available parameter values. The
parameter value that is currently set is highlighted.