ABB LST300 - Menu: Display

LST300 | COMPACT ULTRASONIC LEVEL TRANSMITTER | LST300–EN REV. E
33
Menu / Parameter Value range Description
Device Setup / Process Value / Volume Mode
Volume Mode PV Volume Primary variable for volume mode
Volume Mode SV Temperature
Distance
Volume
Secondary variable for volume mode
Volume Mode TV Temperature
Distance
Volume
Tertiary variable for volume mode
Volume Mode QV Temperature
Distance
Volume
Quaternary variable for volume mode
Menu / Parameter Value range Description
Device Setup / Totalizer
Interval Overflow Num Read Only Interval totalizer overflow counter
Interval Totalizer Display Only Interval totalizer
Overall Overflow Num Display Only Overall totalizer overflow counter
Overall Totalizer Display Only Overall totalizer
Overflow Threshold 




Totalizer overflow threshold
Reset Interval Totalizer - Reset interval totalizer
Enable Totalizer - Enable totalizer
Menu: Display
Menu / Parameter Value range Description
Display
Language English, Chinese Menu language. Only two languages are available.
New languages can be downloaded.
Contrast  Contrast setting for the LCD display
Operator Pages
Up to four user-specific operator pages (layouts) can be configured for the process
display. If several operator pages have been configured, these can be viewed by

Autoscroll Disable, Enable When Multiplex mode is enabled, the “Autoscroll” function can be activated at the
information level.
In this function, operator pages appear on the LCD display at ten-second intervals.
Manual scrolling through pre-configured operator pages as described above is no
longer necessary.
Default setting: Disable
Length Format 



Select the decimal places for the length indicator
Default setting: x.xxx
Flowrate Format 



Select the decimal places for the flow indicator
Default setting: x.x
Volume Format 



Select the decimal places for the volume indicator
Default setting: x.xx
Temperature Format 

Select the decimal places for the temperature indicator
Default setting: x.x
Date/Time Format DD-MM-YYYY
MM-DD-YYYY
YYYY-MM-YYYY
Select the display format for the date and time
Default setting: YYYY-MM-DD
Display Test
Start the test of the LCD display by pressing “OK”