LST300 | COMPACT ULTRASONIC LEVEL TRANSMITTER | LST300–EN REV. E
35
Menu / Parameter Value range Description
output.
/h
output.
/h
output.
In this menu the volume flowrate value for which the current output is to indicate its
is output at the current output.
output at the current output.
Iout for Alarm Alarm Hi
Alarm Low
Select the status of the current output in error condition.
The output “low” or “high” current is set in the subsequent menu.
Default setting: “Low Alarm”
General Alarm is not configurable.
Low Alarm
Unit: mA
Select the current for Low Alarm
High Alarm
Unit: mA
Select the current for High Alarm
Menu: Process Alarm
Menu / Parameter Value range Description
Process Alarm
Diagnostic History - Display of the alarm history
Clear History Execute Clear the alarm list
Group Masking
Alarm messages are divided into groups. If masking is activated for a group (ON), no
alarm occurs.
Menu / Parameter Value range Description
Process Alarm / Group Masking
Maintenance Required Disable, Enable -
Function Check Disable, Enable -
Out Of Specification Disable, Enable -
Menu: Communication
Menu / Parameter Value range Description
Communication
HART
-
Menu / Parameter Value range Description
Communication / HART
Device Address
Select the HART device address.
output.
Tag
special characters
Enter a HART TAG number as the unique identifier for the device
Descriptor
no special characters
Enter a HART descriptor
Message Display of the alphanumeric TAG number
Manuf. ID Display of the HART manufacturer ID
To Next Page
Loading...
