LST300 | COMPACT ULTRASONIC LEVEL TRANSMITTER | LST300–EN REV. E
31
Menu: Device Setup
Menu / Parameter Value range Description
Device Setup
Access Control
-
Basic Setting -
Unit Setting -
Alarm Limits -
Process Value Setting -
Totalizer -
Menu / Parameter Value range Description
Device Setup / Access Control
Standard Password alphanumeric Set the password for the “Standard” access level
Advanced Password alphanumeric Set the password for the “Advanced” access level
Read Only Switch - Display the switch settings for hardware write protection
Menu / Parameter Value range Description
Device Setup / Basic Setting
Operation Mode Level Mode
Flow Mode
Volume Mode
Select an operation mode
Empty Distance
Distance from sensor to the bottom of the measurement range
Span
Measurement span
Blanking
Distance from sensor where no measurement is possible
Max Change Rate Maximum rate the level can change
Max Power Level Maximum power used
Min Power Level Minimum power used
Echo Selection First Echo
Largest Echo
Average Echo
Echo detection mode
Reset to Factory Default - Reset configuration to default according to the present access level
Menu / Parameter Value range Description
Device Setup / Unit Setting
Unit Length m
cm
mm
feet
inch
Define the unit for all length variable (distance, level, head, span, blanking, etc.)
Unit Flow m
/s, m
/min, m
/h, m
/d
ft
/s, ft
/min, ft
/h, ft
/d
L/s, L/min, L/h
USGps, USGpm, USGph, USGpd
UKGps, UKGpm, UKGph, UKGpd
MILGpd
Define the unit for the flow
Unit Totalizer m
ft
L
USG
UKG
Define the unit for the total flow
To Next Page
Loading...
