ABB OMD800 - Page 36

36
AUTOMATIC CONTROL UNIT, OMD800
7.2.2.4 Device Configuration
In the Device Configuration subpage user can configure programmable digital inputs and outputs, the
thresholds and hysteresis for voltage and frequency, the delay times and the MODBUS communication
protocol. User can also select the language and change the password in this subpage. The attribute se-
lection and its value changes are made by using UP, DOWN and ENTER keys.
The Device Configuration subpage requires a password. Password consists of 4 numbers, it is given by
UP, DOWN and ENTER keys. The default password is 0001. Please, change the default password to your
own. The password is valid one minute after leaving the password-protected subpage. If the password
is forgotten or lost, please, contact product support.
Device Configuration
Digital Inputs
Digital Outputs
Voltage Tresholds
2/12
A07142
Device Configuration
Voltage Hysteresis
Frequency Tresholds
Frequency Hysteresis
6/12
A07169
Device Configuration
Delay Times
Auto Switch to 0
LCD Backlight Timer
9/12
A07185
Device Configuration
Modbus
Language Selection
Change Password
12/12
A07197
Password Authentication
KA00257
0000
Back EditForward
Figure 7.23 Device Configuration requires a password