ABB PST - Page 83

Low Voltage Products & Systems 83
ABB Inc. • 888-385-1221 • www.abb-control.com AC 1006.9 - 5/03
Chapter 7 - Settings and configuration
Frequency fault type of operation (Freq F Op)
Select what operation should be initiated if the frequency
fault occurs (out of range):
Stop– M The motor will stop and a manual reset is required.
Stop– A The motor will stop and an automatic reset is
performed and the motor will restart.
Press Store to save the selected operation.
Heat sink type of operation (HS Temp Op)
Select what operation should be initiated if an over-tempera-
ture occurs:
Stop– M The motor will stop and a manual reset is required.
Stop– A The motor will stop and an automatic reset is
performed and the motor will restart
Press Store to save the selected operation.
Shorted SCR type of operation (SCR SC Op)
Select what operation should be initiated if a fault occurs
with shorted thyristor:
Stop– M The motor will stop and a manual reset is required.
Stop– A The motor will stop and an automatic reset is
performed and the motor will restart
Press Store to save the selected operation.