ABB PVS-175-TL - Page 154

154 Product manual - PVS-175-TL;A.1 Version
EN
Problem Possible causes Solution
It is not possible to
access the Web User
Interface using the IP
address when the
inverter is operating in
“Station Mode –
DHCP”.
An incorrect dynamic IP
address is being used to
access the Web User
Interface or the IP address
could have been modified
by the wireless router to
which the inverter is
connected.
The IP Address used to
access the Web User
Interface was lost.
Access the Web User Interface using via “AP
Mode” (refer to “Access to the Web User
Interface” paragraph to know how to
connect via “AP Mode”) and read the current
IP Address in “CONNECTIVITY > WLAN”
section (“CONNECTIVITY menu”).
Access the Web User Interface using the
“Host Name” that could be obtained writing
this url http://ABB-XX-XX-XX-XX-XX-XX.local
replacing the “X” with the hex digits of the
MAC address of the inverter (it can be found
on the “Communication Identification
Label” placed on the side of the inverter or
applied during the commissioning phase to
the plant documentation). The DNS or
multicast service must be enabled on
router.
Note: This connection method doesn’t work
on Android devices.
If possible, access the pages of the wireless
router web server to which the inverter is
connected and read the new dynamic IP
address assigned to the Inverter.
The wireless router doesn’t
allow the connection to
local IP address. Tipically
this happen on company
networks.
Contact the network administrator to allow
the wireless router to connect to local IP
address.
The device doesn’t allow
the connection to local IP
address. Tipically this
happen with company
devices.
Contact the system administrator to allow
the device to connect to local IP address.
Using an Android
devices, a notification
advise that internet
connection is missing
when trying to
connect to the Access
Point wireless network
created by the inverter
and ask for connection
confirmation.
Known behavior of Android
devices. Android OS always
check if internet connection
are available and ask for
confirmation if it’s not
present.
Confirm the connection request in the
notification of Android devices by clicking
“Yes”.