ABB RED615 - Outputs for Signalling

5.2.2 Outputs for signalling
SO output contacts can be used for signalling on start and tripping of the protection
relay. On delivery from the factory, the start and alarm signals from all the protection
stages are routed to signalling outputs.
Table 35: Output contacts X100:10-14
Terminal Description
X100:10 SO1, common
X100:11 SO1, NC
X100:12 SO1, NO
X100:13 SO2, NO
X100:14 SO2, NO
Table 36: Output contacts X110:14-24 with BIO0005
Terminal Description
X110:14 SO1, common
X110:15 SO1, NO
X110:16 SO1, NC
X110:17 SO2, common
X110:18 SO2, NO
X110:19 SO2, NC
X110:20 SO3, common
X110:21 SO3, NO
X110:22 SO3, NC
X110:23 SO4, common
X110:24 SO4, NO
Output contacts of slot X130 are available in the optional BIO0006 module with
configuration C.
Table 37: Output contacts X130:10-18 with BIO0006 module
Terminal
Description
X130:10 SO1, common
X130:11 SO1, NO
X130:12 SO1, NC
X130:13 SO2, common
X130:14 SO2, NO
X130:15 SO2, NC
X130:16 SO3, common
X130:17 SO3, NO
X130:18 SO3, NC
1MRS758127 C Section 5
Protection relay's physical connections
RED615 101
Application Manual