ABB RED615 - Leds; Keypad

The display view is divided into four basic areas.
1 2
3 4
A070705 V3 EN
Figure 3: Display layout
1 Header
2 Icon
3 Content
4 Scroll bar (displayed when needed)
2.4.2 LEDs
The LHMI includes three protection indicators above the display: Ready, Start and
Trip.
There are 11 matrix programmable LEDs on front of the LHMI. The LEDs can be
configured with PCM600 and the operation mode can be selected with the LHMI,
WHMI or PCM600.
2.4.3 Keypad
The LHMI keypad contains push buttons which are used to navigate in different views
or menus. With the push buttons you can give open or close commands to objects in
the primary circuit, for example, a circuit breaker, a contactor or a disconnector. The
push buttons are also used to acknowledge alarms, reset indications, provide help and
switch between local and remote control mode.
Section 2 1MRS758127 C
RED615 overview
18 RED615
Application Manual