1MDU07205-YN rev. F
REF601 CEI
User’s manual
9
Introduction
Section 1 Introduction
1.1 This manual
This manual contains application and functionality descriptions and connection
diagrams, input and output signals, setting parameters and technical data. The
manual can be used as a technical reference during the engineering phase,
installation and commissioning phase, and during normal service. The manual
can also be used when calculating settings. Instructions on how to operate the IED
during normal service once it has been commissioned and it can be used to fi nd
out how to handle disturbances or how to view calculated and measured network
data in order to determine the cause of a fault
1.2 Intended Audience
This manual addresses system engineers, installation and commissioning person-
nel, who use technical data during engineering, installation and commissioning, and
in normal service. system engineer must have a thorough knowledge of protection
systems, protection equipment, protection functions and the confi gured functional
logics in the IEDs. The installation and commissioning personnel must have a basic
knowledge in handling electronic equipment.
This manual addresses Protection and control engineer responsible for planning, pre-
engineering and engineering. The protection and control engineer must be experienced
in electrical power engineering and have knowledge of related technology, such as
communication and protocols.
The manual also addresses the operator, who operates the IED on a daily basis. The
operator must be trained in and have a basic knowledge of how to operate protection
equipment. The manual contains terms and expressions commonly used to describe
this kind of equipment.
1.3 Document Revision History
Document version Release date Document history
A 17.03.2009 Document released
B 17.04.2009 Document released
C 21.04.2009 Document released
D 25.05.2009 Document released
E 07.08.2009 Document released
F 30.09.2010 Document released
To Next Page
Loading...
Need help?
General
