ABB REF615R - Page 10

Setting the IED IP address in a project...................................................44
Technical key..........................................................................................46
IEC 61850 naming conventions to identify an IED............................47
Setting the technical key....................................................................49
COM600 project......................................................................................52
Importing an IED in a COM600 project..............................................52
Using the Web HMI.................................................................................56
IED User Management...........................................................................57
Section 5 Protection and control engineering......................................61
Application Configuration tool.................................................................61
Function blocks..................................................................................62
Signals and signal management.......................................................63
Function block execution parameters................................................64
Execution order and feedback loops.................................................65
Configuration parameters..................................................................66
Connections and variables................................................................66
Hardware channels............................................................................67
Validation...........................................................................................68
Validation when creating an application configuration..................68
Validation on demand...................................................................69
Validation when writing to the IED................................................70
Parameter Setting tool............................................................................70
Configuration parameter....................................................................71
Setting parameter..............................................................................71
Setting group.....................................................................................71
IED parameter import and export......................................................71
IED parameter organization...............................................................72
Signal Matrix tool....................................................................................72
Load Profile tool......................................................................................75
Opening and closing Load Profile tool...............................................75
Load Profile tool user interface..........................................................78
Information fields...............................................................................79
Fault Record tool....................................................................................79
Opening and closing Fault Record tool.............................................79
Fault Record tool interface................................................................81
Section 6 LHMI engineering................................................................83
Single-line diagram engineering.............................................................83
Diagrams in Graphical Display Editor................................................83
Display window and sequence order............................................84
Table of contents
2 REF615R
Engineering Manual