ABB REG670 - Application

16.3.2 Application
Group alarm logic function ALMCALH is used to route alarm signals to different
LEDs and/or output contacts on the IED.
ALMCALH output signal and the physical outputs allows the user to adapt the alarm
signal to physical tripping outputs according to the specific application needs.
16.3.3 Setting guidelines
Operation: On or Off
16.4 Logic for group alarm WRNCALH
16.4.1 Identification
Function description IEC 61850
identification
IEC 60617
identification
ANSI/IEEE C37.2
device number
Logic for group warning WRNCALH - -
16.4.1.1 Application
Group warning logic function WRNCALH is used to route warning signals to LEDs
and/or output contacts on the IED.
WRNCALH output signal WARNING and the physical outputs allows the user to
adapt the warning signal to physical tripping outputs according to the specific
application needs.
16.4.1.2 Setting guidelines
OperationOn or Off
16.5 Logic for group indication INDCALH
16.5.1 Identification
Function description
IEC 61850
identification
IEC 60617
identification
ANSI/IEEE C37.2
device number
Logic for group indication INDCALH - -
1MRK 502 071-UEN - Section 16
Logic
Generator protection REG670 2.2 IEC and Injection equipment REX060, REX061, REX062 607
Application manual