ABB REG670 - Signal Matrix for Binary Inputs SMBI

SBase: Standard apparent power value to be used as a base value for applicable
functions throughout the IED, typically SBase=√3·UBase·IBase.
23.8 Signal matrix for binary inputs SMBI
23.8.1 Application
The Signal matrix for binary inputs function SMBI is used within the Application
Configuration tool in direct relation with the Signal Matrix tool. SMBI represents the
way binary inputs are brought in for one IED configuration.
23.8.2 Setting guidelines
There are no setting parameters for the Signal matrix for binary inputs SMBI available
to the user in Parameter Setting tool. However, the user shall give a name to SMBI
instance and the SMBI inputs, directly in the Application Configuration tool. These
names will define SMBI function in the Signal Matrix tool. The user defined name for
the input or output signal will also appear on the respective output or input signal.
23.9 Signal matrix for binary outputs SMBO
23.9.1 Application
The Signal matrix for binary outputs function SMBO is used within the Application
Configuration tool in direct relation with the Signal Matrix tool. SMBO represents the
way binary outputs are sent from one IED configuration.
23.9.2 Setting guidelines
There are no setting parameters for the Signal matrix for binary outputs SMBO
available to the user in Parameter Setting tool. However, the user must give a name to
SMBO instance and SMBO outputs, directly in the Application Configuration tool.
These names will define SMBO function in the Signal Matrix tool.
23.10 Signal matrix for mA inputs SMMI
Section 23 1MRK 502 071-UEN -
Basic IED functions
728 Generator protection REG670 2.2 IEC and Injection equipment REX060, REX061, REX062
Application manual