IEC17000044 V1 EN
Figure 321: Merging unit
19.3.2 Setting guidelines
For information on the merging unit setting guidelines, see section
IEC/UCA
61850-9-2LE communication protocol.
19.4 Routes
19.4.1 Application
Setting up a route enables communication to a device that is located in another
subnetwork. Routing is used when the destination device is not in the same
subnetwork as the default gateway.
The route specifies that when a package is sent to the destination device it should be
sent through the selected router. If no route is specified the source device will not find
the destination device.
19.4.2 Setting guidelines
Routes are configured using the Ethernet configuration tool in PCM600.
Operation for the route can be set to On/Off by checking and unchecking the check-
box in the operation column.
Gateway specifies the address of the gateway.
Destination specifies the destination.
Destination subnet mask specifies the subnetwork mask of the destination.
Section 19 1MRK 502 071-UEN -
Ethernet-based communication
680 Generator protection REG670 2.2 IEC and Injection equipment REX060, REX061, REX062
Application manual
To Next Page
Loading...
