LD0.DPHHPDOC1 Three-phase directional overcurrent
protection - high stage (1)......................................................21
LD0.EFHPTOC1 Non-directional earth-fault and
sensitive earth-fault protection - high stage 1.........................21
LD0.EFIPTOC1 Non-directional earth-fault and sensitive
earth-fault protection - instantaneous stage 1........................21
LD0.EFLPTOC1 Non-directional earth-fault and
sensitive earth-fault protection - low stage 1..........................21
LD0.EFLPTOC2 Non-directional earth-fault and
sensitive earth-fault protection - low stage 2..........................22
LD0.EFPADM1 Admittance-based earth-fault protection
(1)...........................................................................................22
LD0.EFPADM2 Admittance-based earth-fault protection
(2)...........................................................................................22
LD0.EFPADM3 Admittance-based earth-fault protection
(3)...........................................................................................22
LD0.FRPFRQ1 Frequency protection (1)...............................22
LD0.FRPFRQ2 Frequency protection (2)...............................23
LD0.FRPFRQ3 Frequency protection (3)...............................23
LD0.HAEFPTOC1 Harmonics-based earth-fault
protection................................................................................23
LD0.INPHAR1 Three-phase inrush detection........................24
LD0.INTRPTEF1 Transient/intermittent earth-fault
protection................................................................................24
LD0.LEDGGIO1 LHMI LED indications..................................24
LD0.LEDPTRC1 Global protection signals.............................24
CTRL.LLN0 Local/remote state (also present in DNP IIN-
bits).........................................................................................25
LD0.LLN0 Settings supervision..............................................25
LD0.MVGAPC1 Multipurpose binary inputs (1)......................25
LD0.MVGAPC2 Multipurpose binary inputs (2)......................26
LD0.NSPTOC1 Negative-sequence overcurrent
protection (1)..........................................................................26
LD0.NSPTOC2 Negative-sequence overcurrent
protection (2)..........................................................................26
LD0.NSPTOV1 Negative-sequence overvoltage
protection - stage 1.................................................................26
LD0.PDNSPTOC1 Phase discontinuity protection.................27
LD0.PHHPTOC1 Phase overcurrent protection - high
stage 1 ...................................................................................27
LD0.PHHPTOC2 Phase overcurrent protection - high
stage 2 ...................................................................................27
LD0.PHIPTOC1 Phase overcurrent protection -
instantaneous stage 1 ...........................................................27
LD0.PHLPTOC1 Phase overcurrent protection - low
stage 1 ...................................................................................27
Table of contents
2 REF615
Point List Manual
To Next Page
Loading...
