ABB Relion 620 Series - Activating Programmable Leds; Setting Autoscroll Delay

A070922-ANSI V2 EN
Figure 75: Editing the setting group value
The active setting group is indicated with an asterisk * .
6.4.2 Activating programmable LEDs
1. Select Main menu/Configuration/Programmable LEDs.
2.
Select a programmable LED with or .
3.
Press to enter the selection and to change the programmable LED mode.
4.
Change the mode with or and press to confirm the selection.
6.4.3 Setting autoscroll delay
Autoscroll delay parameter sets the delay of scrolling down measurements view if it is set
as default view and the user is logged out. Autoscroll is active if the delay value is not zero.
1.
Select Main menu/Configuration/ HMI/Autoscroll delay and press
.
2.
Select delay time with or .
3.
Press to confirm the selection.
Section 6 1MAC456939-IB D
Operating procedures
98 620 series ANSI
Operation Manual