1. To enable the WHMI, select Main menu/Configuration/HMI/Web HMI mode
via the LHMI.
2. Reboot the relay for the change to take effect.
3. Log in with the proper user rights to use the WHMI.
4.2.1 Logging in
1. Open Internet Explorer.
2. Type the protection relay's IP address in the Address bar and press ENTER.
3. Type the username with capital letters.
4. Type the password.
GUID-E14731B1-A29E-4BC0-BC6F-8F61E154F993-ANSI V1 EN
Figure 29: Entering username and password to use the WHMI
5. Click OK.
The language file starts loading and the progress bar is displayed.
4.2.2 Logging out
The user is logged out after session timeout. The timeout can be set in Main menu/
Configuration/HMI/Web HMI timeout.
• To log out manually, click Logout on the menu bar.
Section 4 1MAC456939-IB D
Using the HMI
56 620 series ANSI
Operation Manual
To Next Page
Loading...
