ABB Relion 620 Series - Changing the Local HMI Language; Changing Display Symbols

4.1.7 Changing the local HMI language
1.
Select Main menu/Language and press .
2.
Change the language using or .
3.
Press to confirm the selection.
4. Commit the changes.
A071010 V2 EN
Figure 17: Changing the LHMI language
To change the language using a shortcut, press
and simultaneously
anywhere in the menu.
4.1.8 Changing display symbols
Use the keypad to switch between the display symbols IEC 61850, IEC 60617 and ANSI.
1.
Select Main Menu/Configuration/HMI/FB naming convention and press .
2.
Change the display symbols with or .
3.
Press
to confirm the selection.
The protection relay has to be rebooted if the WHMI display symbols are
changed. With the LHMI, the change takes effect immediately.
Section 4 1MAC456939-IB D
Using the HMI
46 620 series ANSI
Operation Manual