A070860-ANSI V2 EN
Figure 18: Scroll bar on the right
•
To scroll the view upwards, press .
•
To scroll the view downwards, press
.
•
To jump from the last row to the first row, press again.
•
Press
to jump from the first row to the last row.
•
To scroll parameter names and values that do not fit the screen, press . Press
once to return to the beginning.
4.1.9.3 Changing the default view
The default view of the display is Measurements unless set otherwise.
1.
Select Main menu/Configuration/HMI/Default view and press .
2.
Change the default view with or .
3.
Press to confirm the selection.
4.1.10 Viewing single-line diagram
The single-line diagram is created with PCM600. The single-line diagram is active only
when the large screen is used.Upon startup, SLD page 1 is set as the default page.
•
Select Main menu/Control/SLD to view the single-line diagram or press
to
navigate between main menu, measurement and single-line diagram.
Section 4 1MAC456939-IB D
Using the HMI
48 620 series ANSI
Operation Manual
To Next Page
Loading...
