6.1.1.9 Adding a busbar
1. Add at least two Busbar Junction elements from the Symbol Library to the
display page.
2. Select the Busbar Junction and use the rotate command from the toolbar to
ensure that the busbar ends to the margin.
3. Add links between the busbar junctions.
GUID-7A12AC16-A189-4337-9634-D2A4AF122C2D V1 EN
Figure 69: Graphical Display Editor: drawing a busbar and placing busbar
junctions
1
Busbar junction
2 Rotate command
4. Add a link between one busbar junction point and the corresponding symbol or
junction point.
6.1.1.10 Adding symbols into a display page
1. Prepare the body of the single-line diagram by locating symbols to the wanted
positions on the display.
2. Drag the apparatus or transformer symbols into a raster box.
3. Drag the connection symbols into a raster box.
4. Place the junction points.
Do not connect two symbols directly to each other. Instead, add a junction
between them.
5. Use the X and Y coordinates in the Object Properties window to adjust the
placement of symbols in the single-line diagram.
Section 6 1MRS757810 C
LHMI engineering
98 REC615 and RER615
Engineering Manual
To Next Page
Loading...
