GUID-2DD837B5-6B0B-48BE-A907-A838C34908E7 V1 EN
Figure 11: Setting the technical key
3. In Set Technical Key dialog box, select the technical key to be used. There are
three alternatives.
• Use the existing technical key in the IED
• Use the existing technical key defined for the IED object in PCM600
• Set a user-defined technical key, which changes the technical key for both
the physical IED and IED object in PCM600
4. Click OK to confirm the selection.
It is not possible to set a user-defined name or select the
Technical key in IED if the value is the same as already given
to another IED object in the PCM600 project. An error message
is displayed if this happens.
3.5 Communication between PCM600 and the protection
relay
The communication between the protection relay and PCM600 is independent of the
used communication protocol within the substation or to the NCC.
All communication is done over Ethernet using either IEC 61850 or FTP/FTPS
protocol.
1MRS757810 C Section 3
PCM600 tool
REC615 and RER615 33
Engineering Manual
To Next Page
Loading...
