GUID-6BE9DC1E-86E5-464F-B9AD-4B782F3D360C V4 EN
Figure 33: Alternative 2: Setting the IP address in IED's Object Properties dialog
box
Choosing between the two ways depends on when the IP address is set. Typing the IP
address via the IED's Object Properties dialog box is possible at any time while
entering it via the configuration wizard can only be done when adding the IED object.
1. In the Plant Structure view, select the IED to which the IP address is to be
entered.
2. On the View menu, select Object Properties.
Object Properties dialog box is opened.
3. Type in the IP address to the IP Address row.
4.5 COM600S project
The 615 series connectivity package supports SAB600. A 615 series protection relay
is imported as a 615 series device. It is also possible to import a full PCM600 project
including several 615 series devices to SAB600. In this case, PCM600 project
information is imported to SAB600 using a SCD file.
The 615 series device supports several functions in COM600S.
• Controlling the switchgear
• Monitoring the measured values
• Reading disturbance recordings
• Setting parameters
Section 4 1MRS757810 C
Setting up a project
56 REC615 and RER615
Engineering Manual
To Next Page
Loading...
