The needed information is delivered with switch controller (of type CSWI) for an
apparatus and all the configured function blocks with measurements (of type MMXU)
for the measurements
1. Right-click the apparatus symbol and select Select Input Signal.
A list of engineered switch control application function blocks opens.
2. Select the switch control application function block that corresponds to the
selected apparatus.
3. Right-click the measurement symbol and select Select Input Signal.
A list of the engineered measurement application function blocks opens.
4. Select the measurement application function block that corresponds to the
selected symbol.
GUID-83D3B54C-BF87-4F27-A5C0-02B93CF3EAA5 V1 EN
Figure 72: Graphical Display Editor: input signal selection
The ordering number in the selection window of the process objects corresponds
to the number given in the Parameter Setting tool tree and to the application
function block in the Application Configuration tool.
Only the apparatus and measurements that are configured in the application
configuration program are displayed.
1MRS757810 C Section 6
LHMI engineering
REC615 and RER615 101
Engineering Manual
To Next Page
Loading...
