ABB SACE Emax 2 Series - Page 263

ABB | SACE Emax 2
Other electronic accessories
10
- Testing and Programming
260 | © 2023 ABB | 1SDH001330R1002 - ECN000297030
Ekip Programming and Ekip
T&P
Ekip Programming is a supply and communication accessory that is useful for:
• Ekip Touch to be supplied and the tripped protection to be displayed, in the event of a TRIP and
absence of auxiliary voltage
• the protections and certain parameters to be set before installation in the system
• with Ekip Connect software, accessing the programming, measuring pages and other exclusive
functions (Datalogger, Dataviewer, Power Controller, Load Shedding, IPS, IEC 61850)
• with Ekip Connect software, accessing the programming, measuring pages and other exclusive
functions (Datalogger, Dataviewer, IEC 61850)
IMPORTANT:
• Ekip Programming can also be connected to Ekip Touch when in service.
• Ekip Programming only supplies the Trip unit: the presence of an auxiliary supply is
required in order to set and display the information about the electronic accessories
Ekip Programming connects to the USB port of the PC, from which it receives the power required to
switch on and also supply Ekip Touch; connection to the service connector of Ekip Touch must be made
with the supplied cable.
Ekip Programming has two leds, one green to indicate when the module is on, the other yellow to indicate
when communication is activated.
Ekip T&P is a supply and communication accessory with the same characteristics as Ekip Programming ,
plus a further function:
• with Ekip Connect software, it enables access to the test pages