ABB SACE Emax 2 Series - Testing and Programming

To Next Page

To Previous Page

ABB | SACE Emax 2

Other electronic accessories

10 -

Testing and Programming

10 - Testing and Programming

Ekip TT

is a supply accessory and is useful for powering Ekip Touch in the absence of auxiliary power

supply; the unit allows:

• Ekip Touch to be supplied and the tripped protection to be displayed, in the event of a TRIP and

absence of auxiliary voltage

• the protections and certain parameters to be set before installation in the system

IMPORTANT:

• Ekip TT can also be connected to Ekip Touch when in service.

• Ekip TT only supplies the Trip unit: the presence of an auxiliary supply is required in order

to set and display the information about the electronic accessories

Ekip TT is connected to the service connector of Ekip Touch by means of the supplied cable.

To switch on the module, set the side switch to the ON position and check the status of the led:

• if green, proceed with the required reading and configuring operations

• if red, replace the batteries of the device (three 1.5 V AA batteries)

Further details are available in ABB Library, especially in document 1SDH001000r0519

Other manuals for ABB SACE Emax 2 Series