ABB | SACE Emax 2
Mechanical accessories
2 - Mechanical safety accessories
185 | © 2023 ABB | 1SDH001330R1002 - ECN000297030
2 - Mechanical safety accessories
KLC: open position key lock
The KLC locks the circuit-breaker in the open position.
It can also be used during maintenance activities on the circuit-breaker after removal of the cover of the
accessory area.
The KLC lock is available with two types of locking:
• lock with different key code numbers (for a single circuit-breaker)
• lock with the same key code number (for more than one circuit-breaker). The maximum number
of key code numbers available is five.
If set up appropriately, the KLC-A lock can work with four other types of locks:
• Ronis
• Profalux
• Kirk
• Castell
NOTE:
the supply of Ronis - Profalux - Kirk - Castell locks is at customer's expense.
KLC for E1.2 KLC for E2.2 - E4.2 - E6.2
Information on the assembly is available on the website http://www.abb.com/abblibrary/
DownloadCenter/, in particular for E1.2 in the kit sheets
• 1SDH000999r0702 for key locks with lock supplied by ABB
• 1SDH000999r0703 for the key locks with pre-engineering for Ronis - Profalux - Kirk locks
• 1SDH000999r0718 for the key locks with pre-engineering for Castell locks
and for E2.2-E4.2-E6.2 in the kit sheets:
• 1SDH001000r0702 for key locks with lock supplied by ABB
• 1SDH001000r0703 for the key locks with pre-engineering for Ronis - Profalux - Kirk locks
• 1SDH001000r0718 for the key locks with pre-engineering for Castell locks
PLC: padlock
The PLC locks the circuit-breaker in the open position.
It is available in two types:
• lock usable with a maximum number of three padlocks with a diameter of 4 mm - 5/32"
• lock usable with a maximum number of two padlocks with a diameter of 8 mm - 5/16"
• lock for a padlock with a diameter of 7 mm - 1/4"-17/64"
WARNING!
The padlock diameter must be respected for safe operation. Smaller diameters than in-
dicated can result in undesired and unsafe operation. This accessory is meant to be used
for regular lock devices with specific shackle diameters. The use of a hasp is not allowed.
Please contact ABB for further information on different dimensions needs.
NOTE:
The padlocks are at customer's expenses.
Continued on the next page
To Next Page
Loading...
