ABB SACE Emax 2 Series - 5 - Changing parameters and commands

ABB | SACE Emax 2
Ekip Touch - Interface and menus
4 - Menu
48 | © 2023 ABB | 1SDH001330R1002 - ECN000297030
Measurements Menu
Menu Submenus Description Page
Historicals
Trip
Description in dedicated chapter 114
Events List of events recorded 114
Measurements List and description in dedicated chapter 114
Power factor
(1)
- Power factor measurement 117
Frequency
(1)
- Frequency measured 117
Energy
(1)
Energy counters Measurement of energies
117
Reset counters Meter reset command
Energy RESET List and description in dedicated chapter 117
Peak factor
(1)
- Peak factor of each phase 117
Harmonic dist. -
Activation command for current harmonic
distortion monitoring
64
Ekip Synchrocheck
(2)
- Description in dedicated chapter 251
Network Analyzer
(3)
V Sequences
Measurements associated with Network
Analyzer function: list and description in
dedicated chapter
123
3s V Sequences
THD Current
THD Voltages
Counters
Waveforms
Maintenance
Contact Wear
Installation and maintenance dates and
commands
133
LastServiceContactWear
Installation
Last Maintenance
Service RESET
(1)
available if provided for by Trip unit model or if SW Measuring Measurements package has been
activated
(2)
available when Ekip Synchrocheck module is present
(3)
available if provided for by Trip unit model or if Network Analyzer SW package has been activated