ABB SACE Emax E4.2 - Page 278

ABB | SACE Emax 2
272 | © 2017 ABB | 1SDH001330R0002 - ECN000058721 Rev. A Mechanical accessories | 4 - Operating modes for E2.2-E4.2-E6.2
Continued from the previous page
5. Make sure that the signalling device indicates the DISCONNECT position. See Figure 55.
Figure 55
6. Grip the guide levers of the fixed part and push them until the moving part stops. See Figure 56.
Figure 56
7. Extract the disconnection crank from its housing See Figure 57.
8. Press the lock pushbutton and insert the crank in the moving part. In this phase the moving part is still
in DISCONNECT position. See Figure 58.
Figure 57
2
1
Figure 58
Continued on the next page