1SDH002031A1002 ECN000092998 Rev. B SACE Tmax XT2 – XT4 | 158
Activating the local bus is required to start communication between the module and Ekip Touch
and is available in the Settings menu (page 128).
If the module is detected correctly by Ekip Touch, in the Settings Modules menu, the following
communication parameters can be configured:
Defines whether the module has the dynamic IP address
(Off) or static IP address (On); if = On all the associated
parameters are enabled
Enables the static IP to be selected
Enables the subnet mask to be selected
In the presence of several subnets it enables the IP address
to be selected of the node to which the module is connected
If the module is detected correctly by Ekip Touch in the About-Modules menu the following
information is available:
Identification and SW version of the module
Address of the module, assigned to the module by a DHCP server at the
moment of connection to the network in the event of configuration with dynamic
or settable IP that can be set by the menu in the event of a static IP
NOTE: without a DHCP server, the module automatically adopts a
causal IP address in the interval 169.254.xxx.xxx
Subnet mask; identifies the method for recognizing the subnet to which the
modules belong and enables modules to be searched for within a defined set of
recipients
IP address of the node to which the module is connected, in the presence of
several subnets
Address assigned by ABB with OUI (Organizationally Unique Identifier) equal to
ac:d3:64 that identifies uniquely the manufacturer of an Ethernet device
To Next Page
Loading...
