Ekip Signalling 10K is an external accessory signalling module, which can be installed on a
standard 35 mm DIN guide (DIN EN 50022, type TS 35x15 mm).
The module has:
Ten programmable output contacts.
Ten or eleven programmable digital inputs.
One startup LED and twenty or twenty-one signalling LEDs (one for each output/input).
The module can be set in four different configurations
One in the case of a connection to a bus link network.
Three configurations in the event of connection via Local Bus (to enable up to three modules
to be connected to the same release)
The module can can be supplied at 110-240 VAC / DC or 24-48 VDC.
More information on Ekip Signalling 10K is available on the website
http://www.abb.com/abblibrary/DownloadCenter/, document 1SDH001318R0002.
IMPORTANT: make sure that you have read the safety requirements and
requirements regarding prevention of unauthorized accesses.
To Next Page
Loading...
