ABB SACE Tmax XT2 - Page 160

1SDH002031A1002 ECN000092998 Rev. B SACE Tmax XT2 – XT4 | 160
Remote
information
From the service connector (via Ekip Connect) or with communication by system bus, it is
possible to access additional information:
Information
Description
HW and Boot version
general module information
Flash CRC status and result
information on the correctness of the SW in the module
Ekip Link status
Signals connection errors of the Ethernet cable
SNTP Server Error
Communication error with the SNTP server
SNTP Server Synchronisation
Synchronism status with SNTP server
IEEE 1558 status
Valid with IEEE 1588 Master = ON, communicates the presence (Slave
or PTP Master Active) or absence (PTP Master but Passive) of a higher
level master
Remote Link
information
Further link function parameters are available:
Information
Description
Line Congruency detection
Information on status and unsuitability of HW and logic
selectivity (status and unsuitable selectivity type)
Remote programmable statuses
(True/false) status of the remote programmable statuses A,
B, C and D
Remote programmable Word status
value of the remote programmable Word A, B, C, D
Zone logic selectivity
Statuses of the logic selectivity (inputs and outputs)