ABB TTR200 - Operator Liability; Personnel Qualification; Returning Devices; Disposal

Safety
8 TTR200 OI/TTR200-EN
Pos: 4.16 /Sicher heit/Allgemein/Organis atorische Maßnah men/Pflichten des Betrei bers @ 0\mod_11297288805 99_3101.doc @ 3246
1.6 Operator liability
Before the use of corrosive and abrasive measuring fluid, the operator must clarify the
resistance of all parts that come into contact with the fluid to be measured. ABB will gladly
support you with the selection, however, cannot accept any liability.
The operators must strictly observe the applicable national regulations in their countries with
regards to installation, function tests, repairs, and maintenance of electrical devices.
Pos: 4.17 /Sicher heit/Allgemein/Organis atorische Maßnah men/Qualifikation des Per sonals @ 0\mod_1129728 800194_3101.doc @ 3247
1.7 Personnel qualification
The installation, commissioning and maintenance of the device may only be carried out through
trained specialist personell authorized by the plant operator. The specialist personnel must have
read and understood the manual and comply with its instructions.
Pos: 4.18 /Sicher heit/Allgemein/Organis atorische Maßnah men/Rücksendung von Gerä ten @ 0\mod_1129730744499 _3101.doc @ 3248
1.8 Returning devices
Use the original packaging or a suitably secure packaging for returning the device for repair or
for recalibration. Include the properly filled out return form (see attachment) with the device.
According to EC guidelines for hazardous materials, the owner of hazardous waste is
responsible for its disposal or must observe the following regulations for its shipping:
All delivered devices to ABB Automation Products GmbH must be free from any hazardous
materials (acids, alkali, solvents, etc.).
Pos: 4.19 /Sicher heit/Allgemein/Organis atorische Maßnah men/Entsorgung @ 10\mod_11764 47410937_3101.doc @ 81544
1.9 Disposal
ABB Automation Products GmbH actively promotes environmental consciousness and has an
operational management system in accordance with DIN EN ISO 9001:2000, EN ISO
14001:2004 and OHSAS 18001. Our products and solutions should have minimum impact on
the environment and persons during manufacture, storage, transport, use and disposal.
This includes the environmentally friendly use of natural resources. Through its publications
ABB conducts an open dialog with the public.
This product/solution is manufactured from materials that can be reused by specialized
recycling companies.