ABB XFC G5 - Install Antenna (for Wireless Functionality); Install the Radio

38 | XSE RI ES G5 | 210602 6MNAA
NOTICE – Equipment damage: Do not over-tighten the terminal connector screws as this may
damage the wires.
Reinsert the terminal connector in the J7 terminal block.
IMPORTANT NOTE: The XSeries
G5
Wi-Fi Kit 2106049AIAB is required for antenna installation.
See Additional information.
Install the antenna to support onboard Bluetooth
®
and Wi-Fi
®
wireless interfaces.
Use onboard connector ANT-1 (J42) to connect the antenna.
Use the cap to isolate the unused antenna connector (ANT-2).
Place communication equipment, such as a radio in the communication compartment, inside of the
enclosure. For radios with serial interfaces, use the available onboard COMM port. COMM1 port is
preconfigured for remote communication and can be used for the radio. See section 5.1 COMM port
description.