Abicor Binzel CAT2 - User Manual

Abicor Binzel CAT2

92 pages

Save Page as PDF

To Next Page

To Next Page

Loading...

T E C H N O L O G Y F O R T H E W E L D E R ´ S W O R L D .

www.binzel-abicor.com

DE Betriebsanleitung / EN Operating instructions

FR Mode d’emploi / ES Instructivo de servicio

CAT2

DE Roboterhalterung

EN Robot mount

FR Support robot

ES Soporte para robot

Table of Contents

Questions and Answers

S
Sarah JarvisAug 11, 2025
What to do if Abicor Binzel Racks & Stands CAT2 does not reset to zero position?
- D
  Daniel NorrisAug 11, 2025
  If the CAT2 does not reset to zero position, it might be due to several reasons. First, the mounted load could be too heavy, so reduce the mounted load and observe the manufacturer's data. Second, there might be a mechanical defect, requiring you to send in the CAT2 for service reparation. Finally, check the fastening of the mounting parts, as they may not be fixed correctly.
N
Natalie GrayAug 21, 2025
Why Abicor Binzel CAT2 Racks & Stands torch mount cannot be mounted?
- J
  John AndersonAug 22, 2025
  The torch mount may not be mountable because the wrong torch mount is being used; ensure you use the correct torch mount. Alternatively, the mounting flange of the CAT2 could be defective, in which case you should send the CAT2 in for service reparation.
A
Adriana TorresSep 1, 2025
What to do if Abicor Binzel Racks & Stands CAT2 does not switch stop signal?
- K
  kiara80Sep 1, 2025
  If the CAT2 does not switch the stop signal, first check if the cable between the CAT2 and the cable assembly is connected; if not, connect the cable. If the cable is connected, it might be defective and needs replacement. Another possibility is a defective CAT2 switch housing, which would require sending the CAT2 in for service reparation.

Abicor Binzel CAT2 Specifications

General

Brand	Abicor Binzel
Model	CAT2
Category	Racks & Stands
Language	English