EN - 21
CAT2 10 Troubleshooting
10 Troubleshooting
Please observe the attached document "Warranty". In the event of any doubts
and/or problems, please contact your retailer or the manufacturer.
Risk of injury and machine damage when handled by
unauthorized persons
Incorrect repair work and changes of the product may lead to significant
injuries and machine damage. The product warranty will be rendered
invalid if the unit is handled by unauthorized persons.
• Operating, maintenance, cleaning and repair work may only be carried
out by qualified personnel (in Germany see TRBS 1203).
• Please also consult the operating instructions for the welding
components, such as power supply, compressed air line.
Fault Cause Solution
Torch mount cannot
be mounted.
• Wrong torch mount used • Use correct torch mount
• Mounting flange of the CAT2
defective
• Send in the CAT2 for service
reparation
CAT2 does not switch
stop signal
• Cable between CAT2 and cable
assembly is not connected
• Connect cable
• Cable defective • Replace cable
• CAT2 switch housing defective • Send in the CAT2 for service
reparation
CAT2 does not reset
to zero position
• Mounted load is too heavy • Reduce mounted load
• Observe the data of the
manufacturer
• Mechanical defect • Send in the CAT2 for service
reparation
• Mounting parts (mount etc.) not fixed
correctly
• Check the fastening of the
mounting parts
Tab. 13 Troubleshooting
To Next Page
Loading...