Installation – Installing and connecting the E3BLTE1 |
25
2 Disconnect the wallbox from the electricity supply
via the integrated RCCB and MCB.
3 Loosen the screw holding the internal electronic
components cover in place using the screwdriver
(Torx) and put it aside.
y Keep the screw in a safe place.
4 Degrease the area on the right hand side of the in-
ternal lining using an alcohol swab.
5 Remove the rear protective foil from the LTE anten-
na and stick it to this position.
6 Lay the antenna cable along the edge of the inter-
nal lining to the connections area on the inside of
the wallbox.
7 Open the connection marked LTE1 in the upper part
of the LTE USB stick, and carefully insert the plug of
the antenna cable there.
8 Plug the LTE USB stick into the Type A port of the
USB switch.
To Next Page
Loading...
