EasyManuals Logo

ABL Wallbox eMH3 User Manual

ABL Wallbox eMH3
36 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #8 background imageLoading...
Page #8 background image
Important InformatIon
4
DANGER!
Should you detect damage to the housing, charging socket or charging
cable, you must take the wallbox out of operation immediately via the
upstream fuse(s) in your domestic power distribution box and the internal
residual current circuit breaker: No further use of the wallbox is permitted
in this case! Please contact your local ABL technical support!
User information
To operate your wallbox, please note these instructions:
The device must always be connected to the protective earth conductor of your
electricity supply. The protective earth connection will be made and checked by the
installing contractor. After installation, only qualified specialist electrical contractors
may make changes.
The wallbox should not be installed in areas of high pedestrian traffic. Installation
along thoroughfares and marked escape routes should be especially avoided.
When there is no charging procedure under way, the charging cable should always
be unplugged and stored to avoid trip hazards.
Ensure that the rated voltage and rated current of the device comply with the pa-
rameters of your local electricity grid and that the rated output is not exceeded dur-
ing the charging procedure.
At all times comply with local safety regulations for the country in which you operate
the wallbox.
To disconnect the wallbox completely from the power grid, the power supply must
be interrupted using the upstream fuse(s) and the internal residual current circuit
breaker (RCCB).
Never operate the wallbox in a confined space. In particular, you must ensure that
the vehicle can be parked at a suitable distance from the wallbox and connected
without any strain on the charging cable.
A parking spot for the vehicle must be planned for in the area in front of the wallbox.
The distance between vehicle and wallbox should be at least 50 cm and no more
than 5 m.
Make sure that the cover of the wallbox housing is always closed and locked when
in use. Keep the triangular key for unlocking the door in a place that is only acces-
sible to authorized users.
Under no circumstances remove the protective cover for electronic components
located behind the housing cover of the wallbox.

Other manuals for ABL Wallbox eMH3

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ABL Wallbox eMH3 and is the answer not in the manual?

ABL Wallbox eMH3 Specifications

General IconGeneral
ModeleMH3
ManufacturerABL
CategoryAutomobile Battery Charger
Charging Power22 kW
Number of Charging Points1
Connector TypeType 2
InstallationWall-mounted
CommunicationOCPP 1.6
IP RatingIP54
Charging Current32 A
Operating Temperature-30°C to +50°C
Charging Power OptionsAdjustable
Input Voltage400 V
Output Voltage400 V

Related product manuals