138
9.9 Plays your own ring tones in the door station monitor
You can load your own ring tones in *wav format to your monitor using the ABUS CMS software.
To do this, open remote configuration for the respective monitor and go to “Intercom” in the “Ring
import” menu. Select an open slot here and upload the *WAV audio file. Once it has
successfully uploaded, the file will be available under “ring tones” directly on the monitor.
Attention: A ring tone selected in the monitor cannot be erased using ABUS CMS. First select
another ring tone in the monitor and then try again to erase the ring tone in CMS.
The WAV file must fit the following parameters:
Format：wav；
Maximale size：≥300Kb；
Bit rate：8KHz；
Channel: Mono
Bit rate: 128Kbps
To Next Page
Loading...
