96
4.2 Activation options / initial password assignment
4.2.1 Activation via door station monitor
1) Establish the system’s power supply and make sure that the door station is also located in
the same network.
Assign a password during initial monitor setup. This password will also automatically be used
for door station activation. The password will also be required for the password-protected
area of the monitor.
- 8-16 characters
- valid characters: numbers, lower-case letters, capital letters, special characters ( ! $ % & / (
) = ? + - )
- You must use at least two different types of character
2) Select the desired language and confirm by clicking “CONTINUE”.
Language assistant 1/4
English
Deutsch
Italiano
Francais
Dutch
Firmware version note
Function: Dutch language
Video module (THVS20000(
S) / TVHS20010(S)): V2.2.3_build_201029
Monitor (TVHS20200 / 210
220): V2.1.2_build_201029
3) Now choose between DHCP / Fixer IP address. It is highly encouraged to assign each
separate device a fixed IP address, as otherwise new IP addresses may be assigned in the
event of a power outage and this can cause serious disruptions in the system.
Network assistant 2/4
DHCP
Local IP 192.168.0.11
To Next Page
Loading...
